Hard‑X‑ray pulses as short as 100‑400 attoseconds recorded at 9 keV
Researchers at LCLS measured the briefest high‑energy X‑ray bursts ever, using a split‑beam ASE diagnostic. The achievement extends attosecond science into the 9 keV regime, opening new possibilities for probing atomic‑scale dynamics.
The measured pulses carried photon energies of about 9 keV.1
Story
Record‑breaking attosecond hard X‑ray pulses and their implicationsScientists at the Linac Coherent Light Source have measured X‑ray pulses that last only a few hundred attoseconds.1 The pulses carry photon energies around 9 keV and their durations range from 100 to 400 attoseconds.1 These results were reported in the journal Nature Photonics.1 Because the pulses are so brief, they can capture electron dynamics that occur on the natural timescale of electronic motion, which is typically a few hundred attoseconds.1 The ability to generate such short, high‑energy bursts marks a milestone for the LCLS facility, which previously had only demonstrated attosecond pulses at lower photon energies.1
Agostino Marinelli explained that such energetic, ultrashort bursts can probe deep inside atomic systems and freeze electronic motion in time.1 He also noted that confirming pulse lengths of only a few hundred attoseconds required a novel diagnostic, the first of its kind for this regime.1 The pulses’ high photon energy gives them the ability to reach deeper into materials, extending the range of atomic systems that can be probed.1 This deeper penetration is crucial for studying dense matter, where electrons are tightly bound and conventional probes cannot resolve their rapid dynamics.1
Lead author Ichiro Inoue proposed an indirect measurement method based on amplified spontaneous emission.1 In this process, an intensely focused X‑ray pulse excites a target element, producing forward fluorescence that encodes the original pulse’s characteristics.1 The ASE signal carries a temporal imprint of the driving pulse because the fluorescence occurs on a timescale much shorter than the pulse itself.1 By analyzing the spectral shape of this fluorescence, the team could infer the pulse duration without directly sampling the attosecond burst.1
The experimental setup split the LCLS beam, directing one portion to a detector for direct energy‑spectrum analysis.1 The remaining beam was focused onto a 150 nm copper foil spot, generating amplified spontaneous emission.1 By combining the spectral data from the detector with the fluorescence signal, the team calculated the pulse duration.1 This dual‑arm arrangement ensured that the energy distribution of the pulse was measured simultaneously with the ASE‑derived timing information, eliminating uncertainties that arise from separate experiments.1 The method leverages the fact that copper’s forward fluorescence is sensitive to the incident X‑ray’s temporal profile, providing a reliable indirect clock for attosecond pulses.1
Earlier work by Marinelli’s group in 2019 produced attosecond X‑rays only in the soft‑X‑ray range, below 5 keV.1 Hard‑X‑ray photons above 5 keV can penetrate farther into matter and locate electrons with atomic‑scale precision.1 The new pulses extend attosecond X‑ray science beyond the soft‑X‑ray range and into the hard‑X‑ray range.1 This energy boost is especially valuable for experiments on high‑density plasmas, where lower‑energy X‑rays would be absorbed before reaching the region of interest.1
Sam Vinko of the University of Oxford highlighted that the new hard‑X‑ray pulses enable direct measurement of core‑excited states in dense plasma before they evolve.1 He also remarked that plasma physics is messy and that these pulses allow observation without relying on indirect modeling.1 Vinko’s comment underscores that traditional plasma diagnostics often depend on simulations to infer transient states, whereas the attosecond hard X‑rays provide a snapshot that can validate or replace those models.1 By capturing the core‑excited configuration before it decays, researchers can map the exact energy flow within the plasma, a capability previously out of reach.1
Inoue emphasized that attosecond hard X‑rays outrun X‑ray‑induced damage, capturing electronic states in their pristine condition.1 Tais Gorkhover of the University of Hamburg plans to use the pulses for improved nanoscale imaging and to explore control of light‑matter interactions.1 She further expressed the belief that these pulses could help reverse X‑ray damage mechanisms.1 Gorkhover’s ambition reflects a broader trend to not only image but also manipulate matter at the atomic level, using the ultrafast nature of the pulses to steer electron dynamics before damage sets in.1 If successful, such control could enable new fabrication techniques that rely on precise, damage‑free modification of materials.1
Interesting Engineering corroborated the pulse durations of 100‑400 attoseconds at roughly 9 keV.2 It described the measurement technique as the same split‑beam approach, with one arm measured directly and the other focused onto a 150‑nm copper spot to generate forward fluorescence.2 The article noted that this pushes attosecond science an order of magnitude beyond earlier soft‑X‑ray experiments below 5 keV.2 By confirming the results across independent outlets, the community gains confidence that the ASE diagnostic truly captures the sub‑femtosecond regime at high photon energy.2 This cross‑validation is important because it demonstrates that the technique is reproducible and not limited to a single laboratory setup.2
Overall, the achievement demonstrates that LCLS can generate hard‑X‑ray pulses only a few hundred attoseconds long, establishing a new benchmark for ultrafast high‑energy photon sources.1
History
How it came to this- 2019Earlier attosecond X-rays were in the soft-X-ray regimeMarinelli's team generated attosecond X-rays below 5 keV.
- UndatedThe team developed an indirect pulse-duration diagnosticInoue proposed using amplified spontaneous emission; the team combined a direct spectrum measurement with fluorescence from a copper target to calculate pulse duration.
- UndatedThe hard-X-ray pulse measurements were reportedResearchers at LCLS measured the shortest high-energy X-ray pulses recorded, with the results published in Nature Photonics.
- Now100 to 400 attoseconds Shortest recorded high-energy X-ray pulse durations
Impact
Spreading outward, level by level- Level 1Measurement of pulse duration
The ASE diagnostic allowed the team to calculate pulse duration by combining the beam's energy-spectrum measurement with the fluorescence measurement.1
Fact - Level 2Studies of dense plasma
Sam Vinko said the pulses let him measure core-excited states in dense plasma before they evolve, and allow direct measurement rather than reliance on modeling.1
Fact - Level 3Nanoscale imaging and light-matter interactions
Tais Gorkhover plans to use the pulses to improve nanoscale imaging and potentially control light-matter interactions.1
Fact - Level 4Potential studies of inaccessible systems
The pulses may enable studies of dense, high-energy systems that soft-X-ray attosecond pulses could not reach.
Analysis
Sources
What each source supportsWritten by AI from the sources listed below: every fact was checked word for word against its source, and inference is marked apart. How we write